Flint Equipment

Information

2023 Landoll 950E 950E-48-15

The 950E Traveling Tail is part of the 900 E Series. The 950E is a 50-Ton capacity and has three 25,000# axles. The 950E offers tail lengths of 12' or 15' tails and 45', 48' and 51' overall lengths. The 950E offers the same rugged four beam construction and other outstanding features of the 900 E Series – standard powder coat paint, stable rigid dock arm, a tail-lifting capacity of 24,000 lbs. and a centralized grease system. Landoll is the only trailer manufacturer to offer powder coat paint on large trailer frames.

Quick, simple, safe operation and a longer wheelbase that increases payload. A 15' tail reduces the load angle to a low 11°. Frames are steel shot blasted in preparation for the TGIC polyester powder coat paint finish standard on 900 Series trailer. The tail can raise and lift 24,000 lbs up to 57" dock height. The 900 E Series is backed by a 5-year structural warranty.

Features may include:

• Capacity: 50 Ton (100,000 lbs.)

• Deck Rating: 70,000 lbs. in 10'

• Estimated Base Weight: 19,890 lbs. (51') +/-3%

• Main Frame: Fabricated 100,000 PSI Yield 4-Beam Design

• Crossmembers: 4" Junior I-Beam and 3" Junior I-Beam on 8" Centers

• Slope Drop: 90°

• Parking Stands: Jost Two Speed Landing Gear

• Pin Setting: 18"

• Swing Clearance: 84"

• Hitch: Fifth-Wheel Kingpin

• Deck Width 102"

• Loaded Deck Height: 38"

• Loaded Ground Clearance: 20"

• Decking: 1-3/8" Apitong Hardwood (Lower Deck)

• Tool Box: Twin Upper Deck Mounted Top-Opening with Non-Weight Bearing Lid Illuminated

• Tie Downs: Double Key Hole Chain Slots / Square Stake Pockets on 16" Centers / (6) Double Keyhole Chain Slots on Tail / (2) D-Rings Lower Deck at Slope

• Tail Lifting Capacity: 24,000 lb.

• Load Angle: 11° with 15' Tail

• Features: Automatic Slack Adjusters, Flat Approach Plate, Apitong Wood Covered Tail, Center Deck Keyholes on Tail, Bolt-On Traction Plate Over Approach Plate

• Suspension: Neway Air Ride RLU228, 22,500 lb. Capacity with Manual Dump Valve

• Undercarriage: Centralized Grease System

• Axles: (3) 25,000 lb. Axles, Dual Tire, Oil Bath Bearings, Outboard Brake Drum, Automatic Slack Adjusters

• Axles Prepped for Air Inflation

• Brakes: 12.25×7.5 Full Air / Spring Brakes ABS 4S2M, Center Axle Indirect

• Tires: 235/75R 17.5 LRJ Double Coin

• Rims: 17.5×6.75 Tubeless

• Wheels: Hub Pilot / Steel Outboard Brake Drums

• Oil Seal Hubs: Internal Mated Assembly

• Hydraulic Hook Up: Quick Couplers / 2,500 PSI – 20 GPM at Controls, 50 GPM Max

• Hydraulic Winch: Upper Deck Worm Gear 12,000 lb. with 85' of 1/2" Cable with Wear Plate

• Hydraulic Valve Body: Rexroth

• Air / Electrical: 7-Way Receptacle

• Lights: Grote MicroNova LED Clear Lens-Enhanced Stop, Tail & Turn; Rear Amber Strobe-10 Year Warranty

• Wiring Harness: Grote “Xtreme” Wiring Harness (7-Year Warranty)